2: Configuring and Installing the Device
8 Verint Video Solutions
11. Select the unknown device, then click Configure. In the Reconfigure unit? confirmation
window, click Yes.
The New Network Configuration window appears.
12. To use DHCP (Dynamic Host Configuration Protocol), check Use DHCP. Otherwise,
enter the IP address, subnet mask, and gateway of the device, as provided by your
network administrator.
For more information about DHCP, see page 43.
13. Click OK.
The device reboots with its new network configuration. It may take up to 20 seconds.
14. In the Units tab, click Discover.
The new S1900e device appears.
15. Select the device, then click Configure.
16. Configure the serial port parameters to match those of the target equipment (for
instance, camera or PTZ keyboard).
For more information, refer to the SConfigurator User Guide.
The S1900e initial configuration is now complete. You perform further configuration with
the web interface (see page 17), SConfigurator, or a video management software from
Verint Video Solutions.
Using the Encoders
The composite signal of a video input for the transmitters is sent to two separate encoders.
You can have the following scenarios with regards to the encoder use:
Note: You should not use the web interface and a video management software at the same
time.
Scenario Encoder 1 Encoder 2
point-to-point point-to-point unused
video management software view at rate A record at rate B
web interface web viewing point-to-point
To Next Page
Loading...
Need help?
General
