A: Factory Default Configuration
42 Verint Video Solutions
The S1900e series is programmed at the factory with the following configuration:
Type Configuration
Serial port
Bit rate: 4800 bauds
Data bits: 8
Parity: none
Stop bit: 1
RS-422/485 operating mode: RS-422 4-wire
Access management
User accounts: Disabled
Telnet sessions: Enabled
IP firmware update: Enabled
Global security profile: Disabled
SSL passkey: <empty>
Network
DHCP configuration: Disabled
IP address: 169.254.*.* (last two bytes of the MAC address of
the device)
Subnet mask: 255.255.0.0
Gateway: 0.0.0.0
Video settings (North America)
Target frame rate: 30 fps
Target bit rate: 800 kbps
Resolution: CIF (352 x 240)
Maximum quantizer: 24
Video standard: NTSC
Receiver mode (on the S1970e-R): Solo
Video settings (Europe)
Target frame rate: 25 fps
Target bit rate: 800 kbps
Resolution: CIF (352 x 288)
Maximum quantizer: 24
Video standard: PAL
Receiver mode (on the S1970e-R): Solo
VSIP
VSIP Port: 5510
VSIP Multicast IP Address: 224.16.32.1
VSIP Discovery IP Address: 255.255.255.255
To Next Page
Loading...
Need help?
General
