Veripos LD8 - 5 Reference Information; Commands List Index

Reference Information
LD8 Operations Manual AB-V-MA-00635_RevA2 26
5 REFERENCE INFORMATION
5.1 COMMANDS LIST INDEX
Commands used within this manual are listed below. Text highlighted in red should be changed as required.
Command
Description
ASSIGNLBANDBEAM 25E
The format for assigning a specific L-band beam
ASSIGNLBANDBEAM AUTO
Setting for automatically tracking L-band beams
GGAQUALITY 4 OUT_OF_BOUNDS 2 WAAS 2 PPP 2
PSRDIFF 2
Set PPP DQI to 2 or 5
IPCONFIG ETHA DHCP
Change IP assignment to DHCP
IPCONFIG ETHA STATIC 192.168.2.8
255.255.255.0 192.168.2.1
Set a Static IP
LOG COM1 GPGGA ONTIME 1
Enable message output on a specified port
LOG IPSTATUSA ONCE
Check current IP settings
LOG LBANDTRACKSTAT
Check tracked L-band beam/s and signal strength/s
LOG VERIPOSINFO
Check unit ID and activation service code
LOG VERIPOSSTATUSA
Check present activation status of LD8
NMEAFORMAT GGA_LATITUDE 10.5
Configure number of Latitude decimal places in GGA
message
NMEAFORMAT GGA_LONGITUDE 11.5
Configure number of Longitude decimal places in GGA
message
PPSCONTROL ENABLE POSITIVE
Set PPS polarity to either positive or negative
PPPSOURCE APEX
Select either Ultra or Apex PPP solution
SAVECONFIG
Saves all settings excluding Ethernet configurations
SAVEETHERNETDATA
Saves any Ethernet configuration settings
SBASCONTROL DISABLE
Disable the SBAS fallback solution
SBASCONTROL ENABLE AUTO
Enable the SBAS fallback solution
SERIALCONFIG COM1 9600 N 8 1 N OFF
Specify a baud rate for a specified port
SERIALCONFIG COM1 115200 N 8 1 N OFF
INTERFACEMODE COM1 VERIPOS_RTCM NOVATEL ON
Input external RTCM specifying port and baud rate
UNLOG COM1 GPGGA
Disable message output on a specified port
UNLOGALL COM1
Stop all messages on a specified port