Introduction
LD8 Operations Manual AB-V-MA-00635_RevA2 6
1.5 ENABLING THE LD8 FOR VERIPOS SERVICES
VERIPOS correction signals are provided as a chargeable service.
In order for the LD8 to decode corrections and output a corrected position it must be activated. The user can
send a request for an activation of services to the VERIPOS Helpdesk and the activation will then be sent via
L-band satellite to the requested unit.
When not in use, some service agreements may allow for deactivation of the service. The
activation/deactivation procedure is detailed in section Activation and Deactivation of VERIPOS Services.
To use VERIPOS correction signals a contract between the users company and VERIPOS must be in place.
VERIPOS call this a Service Access License (SAL).
To avoid delays users should record the SAL number associated with the VERIPOS equipment.
The Helpdesk are unable to activate any equipment unless an active SAL exists, and its reference number
can be determined.
To Next Page
Loading...