EasyManuals Logo

VERITAS NetBackup 5240 User Manual

VERITAS NetBackup 5240
38 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
The iSCSI interface name can only contain numbers (0-9), letters (A-Z and
a-z), colons (:), hyphens (-), under scrores (_) and periods (.) It must begin
with numbers (0-9), letters (A-Z and a-z) and underscores (_) only.
5
Run the Target Discover Portal <Portal Address> <Interface Name>
command. You are asked to provide a username and password. Type yes if
your target requires authentication. The targets that are available on the
specified portal address and interface are discovered and displayed in the
following manner:
Does your target require a username and password? (yes,no)[no]:no
Showing the discovered targets...
+-----+------------------------|---------------------|----------------+
| No. | Target IQN |Target Portal Address| Interfaces |
+-----+------------------------|---------------------|----------------|
| 1 |iqn.1996-03.veritas:abc | 10.121.98.22:3260 | iscsi1, iscsi2 |
+-----+------------------------|---------------------|----------------|
| 2 |iqn.1996-03.veritas:xyz | 10.121.98.23:3260 | iscsi1, iscsi2 |
+-----+------------------------|---------------------|----------------+
| 3 |iqn.1996-03.veritas:host| 10.121.98.24:3260 | iscsi1, iscsi2 |
------|------------------------|---------------------|----------------|
Note: If you run the iSCSI > Target Discover Portal or iSCSI > Target
Discover iSNS command again after the targets are connected, it overrides
the existing connection settings like target credentials. If the target requires
authentication, you will need to enter the target credentials again when the
existing sessions are reconnected. The existing sessions need to be
reconnected if the appliance restarts or when you change the IQN for the
appliance or when the iSCSI processes are restarted etc.
About iSNS
An iSNS server uses the Internet Storage Name Service protocol to maintain
information about active iSCSI devices on the network, including their IP addresses,
iSCSI node names, and portal groups. The iSNS protocol enables automated
discovery and management of iSCSI devices on an IP storage network. An iSCSI
initiator like the NetBackup appliance can query the iSNS server to discover iSCSI
target devices.
27Configuring iSCSI
About iSNS

Other manuals for VERITAS NetBackup 5240

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the VERITAS NetBackup 5240 and is the answer not in the manual?

VERITAS NetBackup 5240 Specifications

General IconGeneral
Language version-
License typeCorporate
License quantity- license(s)
License term in years5 year(s)

Related product manuals