EasyManuals Logo

VERITAS NetBackup 5240 User Manual

VERITAS NetBackup 5240
38 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
To connect to a target
1
Open a Secure Shell (SSH) session to log on to the appliance as an
administrator.
2
Navigate to the Main_Menu > Settings > iSCSI menu.
3
Type the command Target Connect.
4
Enter the IQN and portal address of the discovered target. A user name is
required if authentication is enabled on the target.
Note the following about IQN, portal address, and user name:
The IQN can only contain numbers (0-9), letters (A-Z and a-z), colons (:),
hyphens (-), and periods (.)
Example: iqn.1999-06.com.veritas:storage.lun1
The target portal address must be of the following format: <IP
address/hostname>[:port]. Only IPv4 addresses are supported. The host
name can be a short name or a fully qualified domain name.
Example: 192.116.116.50 or abc:3260
The user name can only contain numbers (0-9), letters (A-Z and a-z),
hyphens (-), underscrores (_), and periods (.). It must begin with numbers
(0-9), letters (A-Z and a-z), and underscores (_) only.
Example: john.smith
5
Run the command to connect to the target. You can connect to one discovered
target at a time.
Disconnecting the sessions with a target
You can use the iSCSI > Target Disconnect command to disconnect sessions
with the target that has the specific IQN and portal address. Once you run this
command, all the sessions that are connected to this target will get disconnected.
You can disconnect sessions with one target at a time.
Note: This command takes more time to complete if workloads are running on the
iSCSI interface.
To disconnect the sessions with a target
1
Open a Secure Shell (SSH) session to log on to the appliance as an
administrator.
2
Navigate to the Main_Menu > Settings > iSCSI menu.
31Configuring iSCSI
Disconnecting the sessions with a target

Other manuals for VERITAS NetBackup 5240

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the VERITAS NetBackup 5240 and is the answer not in the manual?

VERITAS NetBackup 5240 Specifications

General IconGeneral
Language version-
License typeCorporate
License quantity- license(s)
License term in years5 year(s)

Related product manuals