3
Type the command Interface VLAN Set.
4
Enter the VLAN ID and the iSCSI interface name as parameters. Press Enter.
The VLAN ID must be a number from 1 to 4095.
Example:
iSCSI> Interface VLAN Set 75 iscsi10
[Info] The VLAN tag has been configured for iscsi10.
Removing and resetting the interface properties
This section lists the procedures for removing all the interface properties except
MTU. It also contains the procedure to reset MTU to the default value (1500).
The MTU cannot be removed and can only be reset to its default value.
To remove the interface properties
1
Open a Secure Shell (SSH) session to log on to the appliance as an
administrator.
2
Navigate to the Main_Menu > Settings > iSCSI menu.
3
Use the following commands to remove the specific properties:
■ Type the command Interface Gateway Remove and enter an iSCSI
interface name.
This command removes the gateway from the specified interface.
Example:
iSCSI> Interface Gateway Remove iscsi1
[Info] The Gateway has been removed from iscsi1.
■ Type the command Interface IPAddress Remove and enter an iSCSI
interface name.
The command removes the IP address from the specified interface.
Example:
iSCSI> Interface IPAddress Remove iscsi1
[Info] The IP address has been removed from iscsi1.
■ Type the command Interface Netmask Remove and enter an iSCSI
interface name.
24Configuring iSCSI
Removing and resetting the interface properties
To Next Page
Loading...
Need help?
General
