COMPUTER NETWORK CONFIGURATION
2. Enable the protected setup by moving the selector to OnOn.
3. Use one of the following methods:
• If your Wi-Fi client device has a WPS button, press the
unified button on your Router for more than two seconds,
then click the WPS button on your Wi-Fi device (client) to
start the WPS registration process.
• If your client device has a WPS PIN, locate the PIN
printed on the client’s label or in the client documentation.
Enter the PIN number in the Client WPS PINClient WPS PIN field. The
Client WPS PINClient WPS PIN field is located in the section 2 - PIN 2 - PIN
enrollmentenrollment on the user interface.
• Click RegisterRegister.
• Alternatively, you can enter the Router’s PIN shown on
this screen into the WPS user interface of your device, if
this PIN mode is supported by your Wi-Fi device.
To Next Page
Loading...
