VERO BR36 - SETTING;ADJUSTING THE OPERATING TEMPERATURE; SETTINGS;ADJUSTING THE FLOW UNIT AND TEMPERATURE UNIT

Installation and Operation Guide
www.trutankless.com Bollente trutankless® VERO Series Water Heaters
3
SETTING/ADJUSTING THE OPERATING TEMPERATURE
e trutankless VERO BR/BC unit comes preprogrammed for an initial temperature setting of 120°F (49°C). is set point of
residential version can be changed by pressing the Temp Increase or Temp Decrease buttons to control the temperature from
90°F to 140°F (32.2°C to 60°C) in the residential model, or from 90° F to 180° F (32.2° to 82.2° C) in the commercial model, in
single digit increments. Properly used, the trutankless VERO BR/BC water heater will deliver the desired temperature, even
when the water ow varies, or when more than one hot water tap is open. Should the demand for hot water (ow) exceed the
unit’s capability, there will be a corresponding decrease in the temperature of the water delivered.
/
F/ C
GPM
O
F
O
F
O
F
• Press to Increase the set temperature.
• Press to Decrease the set temperature.
You may use higher or lower temperatures to suit your needs. Remember that maintaining lower hot water temperatures
will save additional energy. e eciency of the heater is not aected by mixing in cold water at the point of use because
the trutankless will simply detect a lower ow through the heater and adjust the power accordingly. Most users nd a happy
medium by setting their unit at 120°F.
SETTINGS/ADJUSTING THE FLOW UNIT AND TEMPERATURE UNIT
e initial temperature of the water and ow units are displayed in Degrees Fahrenheit (°F) and Gallons per Minute (GPM).
/
F/ C
GPM
O
F
O
F
O
F
/
F/ C
LPM
O
C
O
C
O
C
• Press to toggle between Fahrenheit and Celsius as they will be displayed on the control screen.
• Press
G
/
L
to toggle between Gallons and Liters as they will be displayed on the control screen.