EasyManua.ls Logo

VERO BR36 - Appendix; Component Terminology

VERO BR36
26 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
24
Bollente trutankless® VERO Series Water Heaters www.trutankless.com
APPENDIX
COMPONENT TERMINOLOGY
Heating Chamber: Made of heat insulator-coated copper tubes connected in series (serpentine), this chamber
is where the water ows through and is heated by over 20 feet (6 meters) of internal
heating elements.
Wiring Harness: is harness provides for the electrical connectivity between the heating elements,
mechanical relays, solid state relays, transformer and the supplementary load center with
quad circuit breakers.
Safety Relays: Eight relays completely cut power to the heating elements in case of a leak, temperature
cutout and rmware fault.
TRIACS: TRIACs regulate, via rmware control, the amount of power to the elements in order to
smoothly heat the water to the desired temperature. Residential units contain four (4)
TRIACs; commercial units contains eight (8).
Over-Temperature Switch: Monitors the internal temperature of the heating chamber.
If the temperature of residential water heater exceeds 158°F (70°C), the Over-Temperature
switch will shut down the heater as a safety precaution. e heater will automatically reset
this switch when the temperature drops back below 122°F (50°C).
If the temperature of commercial water heater exceeds 197.6°F (92°C), the Over-
Temperature switch will shut down the heater as a safety precaution. e heater will
automatically reset this switch when the temperature drops back below 161.6°F (72°C).
Hot Water Outlet: ¾˝ NPT and port for temperature sensing thermistor; heated water comes out at
this location.
Flow Sensor: is sensor determines the incoming water ow rate and communicates that to the
microprocessor controller board.
Incoming Water Inlet: ¾˝ NPT and port for temperature sensing thermistor; where cold water enters the heater.
Wiring Block Access: Electrical wire access to main terminating lugs (2 hot, 1 ground.) Electrical wire is top fed.
Quad Circuit Breakers: Simplifying installation, the circuit breakers provide an internal shut-o to the water
heater. e size of the circuit breakers is dependent on the amperage model of the unit.
Display: Backlit LCD with push-button control.
Controller Board: e brain of the heater. It controls the advanced features including temperature set point, time
of use, startup delay and gallon/time limits.