Need help?Do you have a question about the Vertiv M830D and is the answer not in the manual?
General| Model | M830D |
|---|---|
| Type | Control Unit |
| Input Voltage | 100-240V AC |
| Input Frequency | 50/60 Hz |
| Output Current | 30A |
| Communication Interface | RS-232, RS-485, Ethernet |
| Humidity | 5% to 95% non-condensing |
| Weight | 3.5 kg |
| Operating Temperature | 0 to 50°C |
Details NCU's monitoring of system components and alarm generation logic.
Outlines the various battery management functions provided by the NCU.
Explains user access levels, usernames, and password configurations for local and web access.
Procedures for managing user accounts and configuring IP/DHCP settings.
Configuration of SNMP, TL1 parameters, and automatic battery equalization.
Configuration for battery temperature compensation and thermal runaway management.
Steps for backing up and restoring NCU configuration and settings files.
Procedures for upgrading NCU software and reloading backed-up configurations.
Procedures for restoring factory defaults and rebooting the NCU controller.
Lists prerequisites and safety instructions for paralleling power systems.
Steps to configure the NCU for Power Split and verify its operation.
Lists available alarms, their descriptions, and actions to correct the underlying issues.
Details navigation paths for the Alarm and Settings menus.
Details parameters for rectifier, battery, LVD, and AC settings.
Describes the Alarms Area and the Power System status graphical display.
Provides procedures for viewing and configuring settings for individual modules and batteries.
Configuration of network parameters and user accounts with privilege levels.
Procedures for software maintenance, default configuration restore, and file retrieval.
Configuration of power split mode and associated digital inputs for LVD, battery test, and equalize.
Lists supported TL1 commands, autonomous messages, and error codes.
Safety instructions and step-by-step procedure for replacing the NCU controller.
To Next Page
