SM, MM, DS, NZDS and other options
allow the user to select the appropriate
fiber type and fusion procedure depending
on the type of fiber.
Automatic, semi-automatic and manual
options available
Different fusion parameter No. can be
selected according to the current fiber
type, which can be selected and modified
by the user according to requirements
Edit the current fiber type, fusion
parameters under the current numbering
program
Clean arc means cleaning the smallest of
dust from the fiber surface by discharging
it prior to splicing
Limit values for fiber end face angles
Limit value of the angle of the left and right
fiber after alignment
Limit values for center deviation after
alignment of left and right fiber
The estimated splicing loss exceeds the
limit and the screen displays an indication
After the fusion is completed, the fusion
loss can be reduced by compensating the
discharge under certain circumstances
Core alignment, cladding alignment, fine
alignment can be set
Can be set on or off, fast mode reduces
fusion time when on
To Next Page
Loading...
