VEVOR ALK-T2 - Page 46

- 45 -
sides in the
horizontal and
vertical directions
are greater than
the set threshold.
Estimated loss
amount is
too much
1、 splice loss
exceeds
limit;
2、 The selected
program do
not match
the fiber type
Clean v-groove,
reoperate
【Arc calibration】
then
splice again
Power is too
insufficient
Current
remaining battery
insufficient
Use power adapter
to
charge
Replace
electrodes
Electrodes arc
records
exceed the limit
Replace
electrodes(operate
【Replace
Electrodes】,
【Calibrate
system】)