If any of these tags are missing, illegible, or damaged, they must be
Replaced.
Use this laser engraving device only in accordance with all applicable
local and national laws and regulations.
Use this appliance only in accordance with this instruction manual. Only
others who have read and understood this manual are allowed to install,
operate, maintain, repair, etc. If this device has been given away or sold
to a third party, make sure this manual is included with this device.
Do not run continuously for more than 3 and a half hours. Stop for at least
30 minutes between uses.
Do not leave this device unattended during operation. Observe the
equipment throughout the operation, if there is any abnormal operation,
cut off all power to the machine immediately, and contact our customer
service or your specialized repair service. Again, make sure the
appliance is completely turned off after each use (including via the
emergency stop switch).
Do not allow minors, untrained personnel, or persons with physical or
mental disabilities that would interfere with their ability to follow this
manual and software manuals to install, operate, maintain, or repair this
equipment.
Any untrained personnel who may be in close proximity to the equipment
while operating must be informed that the equipment is dangerous and
given adequate instructions on how to avoid injury during use.
Always place fire extinguishers, water pipes, or other flame retardant
systems nearby to prevent accidents. Make sure the phone number of
the local fire department is clearly displayed nearby. In the event of a fire,
cut off the power supply before extinguishing the flames. Before use,
familiarize yourself with the correct range of the fire extinguisher. Be
careful not to use the fire extinguisher too close to the flame, as its high
pressure can create a backlash.
To Next Page
Loading...
