1.OPERATION OVERVIEW.
Operate this laser engraver only by following all the instructions provided in this
manual. Failure to follow the appropriate guidelines detailed herein may result in
property damage and personal injury.
This section will describe only some of the options and features offered by the
operating software. Before you start using the machine, make sure you have read
the entire manual (especially the safety information above), as well as any and all
warnings provided by the machine itself.
2.GENERAL OPERATING INSTRUCTIONS.
Step 1. Create the design you want to engrave. You can do this directly in the
engraving software, or you can use any
Step 2.Please connect the companion equipment and tools to the product and
connect the power supply. You can refer to the video on CD/USB. Fill the water
inlet with purified or distilled water for the built-in water circulation. The
water level must be added to the green water level safety line. Note: (The
water level should not be too full, so as not to overflow).
Step 3. Please remove the smoke pipe. One end of the smoke pipe is connected
to the smoke exhaust port of the equipment, and the other end is connected
to an outdoor or auxiliary smoke extraction device. Note: (Please use a tube
clamp to secure the connection to prevent it from falling off.)
Step 4. Pull up the emergency stop button and use the buttons on the front of
the cabinet to open the control panel of the engraving machine. Load the
design of your choice directly from a USB flash drive or via a computer's
connection to the engraver.
To Next Page
Loading...
