Connecting the machine directly to the public internet carries the risk of
unauthorized use and is not recommended. If you still wish to provide it,
you'll need to register and use a unique public TCP/IP address. When
you're done making adjustments, save them by selecting the ENT key to
write or pressing the ESC key to leave without saving the changes.
Reading can load saved parameters.
DIAGNOSTIC TOOLS.
After selecting Diagnostics, the left dialog box will pop up:
This interface displays the system's hardware I/O port information:
Input: Read the hardware information of the system. When a hardware
signal is triggered, the small box to the left of the corresponding entry will
be shown in red. Other-wise, it will be grayed out.
Output: Use the cursor to select the output. Press ENT to toggle the output
state, and ESC to return to the main menu without making any changes.
To Next Page
Loading...
