SETTING THE SCREEN REFERENCE.
After selecting the Screen Origin, the left dialog box will pop up:
This interface displays the location of the origin. Different origin positions
can produce different reflections of the graph on the X/Y axis. The
operation method is the same as above.
ADJUSTING THE SCULPT LAYER.
When the system is idle or the work is complete, press ENT to enter the
layer parameters section.
Press ▲ or ▼ to select the desired layer.
Press ENT to check the parameters of the selected layer, as shown in the
image:By default, the red cursor will be over Layers.
Press the ◄ and ► keys to select the desired layer.
Move the cursor to Write and press ENT to save the parameter changes, or
press ESC to exit without saving.
The method of operation is the same as the maximum/minimum power
setting.
To Next Page
Loading...
