1.INSTALLATION OVERVIEW.
A complete working system includes the laser engraving cabinet, its
vents, all applicable connection cables, as well as the laser and access
key. The cabinet can use the design provided by the included engraving
software by connecting directly with your computer or the internet; It can
also engrave designs that are loaded directly from flash drives. Users
can configure other additional accessories, such as rotary axes, to meet
their needs.
Use only the hardware, cabling, and power supplies that come with or are
compatible with this device. Installing equipment that is not suitable for
use may result in poor performance,Reduced service time, increased
maintenance costs, property damage, and personal injury.
Please pay attention to the specific requirements for system installation.
Every customer must be aware of these considerations prior to
installation in order to perform the correct setup and achieve safe laser
performance. If you have any installation issues or problems, please
contact our technicians and customer support team.
Any auxiliary equipment must be adjusted to the main unit. If in doubt,
please contact the dealer or manufacturer of such equipment directly.
2.Installation site selection
Before installing the enggraver, choose the appropriate location for use.
Make sure it meets all the requirements discussed in the above safety
information. The location should be stable, level, dry, and
climate-controlled to ensure an ambient temperature of 40–95°F
(5–35°C) and ambient humidity below 70%. In particular, temperature
and humidity together should not approach the dew point. It is also
advisable to use windowless rooms or to use blinds and/or curtains to
avoid exposure to the potential additional heat of direct sunlight. The
location should be free of dust and other air contaminants and well
ventilated enough to handle any fumes generated during the engraving
process in accordance with all applicable laws and regulations.
To Next Page
Loading...
