when disabled, the small box will be gray. When you select Set Origin or
Next Origin, press◄ or ► to select a value. When changing the Set
Origin parameter, remember to press ENT to verify the change. When you
close the interface, the parameters are automatically saved.
The details of each item are as follows:
·Set Origin 1/2/3/4: After enabling the multi-origin setting, place the cursor
over setting to Origin 1/2/3/4. Press ENTER on your keyboard
key, the system takes the coordinates as the corresponding coordinates of
the origin 1/2/3/4.
·Source Enable 1/2/3/4: When the multi-source setting is enabled, four
sources can also be disabled and enabled individually.
When multi-origin logic is selected, if the number of the next origin is 1, and
four origins are enabled, the work will be used every time it is started when
the save file function is started (via keyboard or PC) or when a processing
file is uploaded to a PC and the file is selected "Take origin as origin".
Different origins. The order of rotation of the origin is 1→2→3→4→1→2...
If you upload a processing file to your PC and you select Current Origin for
the file, the system will always use the current origin.
SET DEFAULT PARAMETERS.
When the facts are set. Select the paragraph and the machine's current
parameters will be stored as their default values. They can then be
retrieved using the Restore Default Parameters command. It is
recommended that you save the actual factory default settings of your
machine so that it can be easily restored if needed.
If the password is enabled, push ◄ or ► and ▲ or ▼ to select the
password, and then press ENT to save the password.
RESTORE THE DEFAULT PARAMETER.
When defining facts. Once a parameter is selected, the system replaces all
current parameters with the saved default factory parameters. The
operation method is the same as setting the default parameters.
To Next Page
Loading...
