Depending on the material to be processed, this may require the
construction of a dedicated ventilation system. It should be kept away
from children; flammable, flammable, explosive or corrosive materials;
and sensitive EMI equipment. The power cord should be
plugged into a compatible and stable power source through a grounded
3-pin outlet. There should be no other items drawing current from the
same fuse. Fire equipment should be available nearby, and the phone
number of the local fire department should be clearly displayed.
It is highly recommended to place an additional bench near the machine
to avoid placing objects on or directly near the machine, which could
become a fire or laser hazard.
3.WIRE GROUNDING.
The device uses a powerful laser. As mentioned in the safety information
above, it has extremely high voltages and potential hazards, so the user
must ground it firmly to avoid static build-up. Using a standard 3-pin
socket will provide adequate grounding. If you don't have access to a
3-pin outlet, you must use a grounding cable and make sure it's properly
connected. The distal end of the cable should be securely attached to a
metal rod at least 8 feet (2.5 meters) deep, or to two separate metal rods
that have been driven into the soil at least 5 feet (1.5 meters) from the
machine.
Poor grounding can lead to equipment failure and create a serious risk of
electric shock. The manufacturer and/or seller shall not be liable for any
damage, accident or injury caused by a poor grounding connection.
To Next Page
Loading...
