4. UNPACK THE ENGRAVING MACHINE.
Your engraver comes in a wooden case with its accessories (including
this manual) packed in the area behind the front through door. You
should place the crate in a generous, flat area for unpacking, and ideally,
you plan to operate the machine permanently.
Step 1: If you haven't already done so, finish removing the crate from
around the engraver. Then roll the machine into place.
Step 2: Hold the brake pads in place by pressing the brake pads on the 2
front wheels.
Step 3: Retrieve the access key from the main bay at the front of the
machine. Remove the accessory bag from the area behind the front
through door. Check that you have received all of the following items:
power cord, ground cable, USB and Ethernet cables, USB flash drive
with engraving software, exhaust pipe with hose clamp, set of hex
wrench, acrylic focusing tool, keys, and this manual.
Step 4 : Carefully inspect the assembly of the laser tube, the viewing
window and the rest of the machine. The laser tube is a highly fragile
object and should be handled with care and as few bumps as possible.
Step 5: Inside the main bracket, remove from the X-axis and the
honeycomb table.
Step 6: You can keep the packaging for future returns, but if you dispose
of it or any accessories, be sure to follow the applicable waste disposal
regulations.
To Next Page
Loading...
