OLP-87/OLP-87P 35
CHANGING SYSTEM SETTINGS
4 BASIC OPERATION
To set 24-hour or 12-hour time:
1. Tap [Time Format].
2. Select the desired time format.
Setting the Ethernet protocol
J In the menu tap the [More] button,
then tap [Ethernet].
To select the IP mode:
1. Tap t h e [IP Mode] button.
2. Select the desired Ethernet mode.
To set the IP address:
I The IP mode Static is selected.
1. Tap [IP Address].
2. Type in the desired IP address.
3. Tap [OK].
To set the gateway:
I The IP mode Static is selected.
1. Tap [Gateway].
2. Type in the desired gateway.
3. Tap [OK].
To set the netmask:
I The IP mode Static is selected.
1. Tap [Netmask].
2. Type in the desired netmask.
3. Tap [OK].
Calibrating the touchscreen
NOTE: Using a pen when calibrating the touchscreen will improve the
calibration accuracy.
1. In the menu tap the [More] button,
then tap [Touchscreen calibration].
2. Follow the given instructions.
Resetting to the factory default values
NOTE: Setting the factory default values does not affect your stored
measurement results.
To Next Page