OLP-87/OLP-87P 65
SETTING AND SELECTING WAVELENGTHS
9 BROADBAND OPERATION
The
table is displayed:
To add a wavelength:
I The Edit Table menu in Powermeter mode is displayed.
1. Press the
[A] key and tap the [Add button.
2. Type in the desired value.
3. Tap t h e [OK] button.
To delete a wavelength:
I The Edit Table menu in Powermeter mode is displayed.
1. Select the desired wavelength.
2. Press the
[A] key and tap the [Delete button.
To edit the reference value:
I The Edit Table menu in Powermeter mode is displayed.
1. Select the desired wavelength.
2. Press the
[A] key and tap the [Edit Reference] button.
3. Type in the desired value.
4. Tap t h e [OK] button.
To edit the Pass/Fail limit for value:
I The Edit Table menu in Powermeter mode is displayed.
1. Select the desired wavelength.
2. Press the
[A] key and tap the [Edit Limit] button.
3. Type in the desired value.
4. Tap t h e [OK] button.
To show or hide wavelengths:
NOTE: A wavelength with a checkmark can be selected by taping the
wavelength field on the measurement display. The wavelengths
shown in the table accessed by the
[A] menu ([A] > ) are
not affected by the settings.
To Next Page