Victron energy MultiPlus-II User Manual

Bulk charging
The AC input voltage is switched through and the charger operates
in bulk mode. The "bulk" LED is on.
BatterySafe
The mains voltage is switched through and the charger is on.
However, the set absorption voltage has not yet been reached. The
"bulk" and "absorption" LEDs are both on.
Absorption charging
The mains voltage is switched through and the charger operates in
absorption mode. The "absorption" LED is on.
Float charging
The mains voltage is switched through and the charger operates in
float mode. The "float" LED is on.
Equalize charging
The mains voltage is switched through and the charger operates in
equalize mode. The "bulk" and "absorption" LED are both blinking.
PowerControl
The AC input is switched through. The AC output current is equal
to the preset maximum input current. The charge current is
reduced to 0A. The "mains on" LED is blinking.
MultiPlus-II 48V 3kVA 120V
Page 8 Operation

Victron energy MultiPlus-II Specifications

General

Model	MultiPlus-II
Inverter Power	3000 VA
Output Power	2400 W
Output Voltage	230 VAC
Output Frequency	50 Hz or 60 Hz
Charger Current	35 A
Efficiency	94%
Weight	18 kg
Input Voltage	230 VAC
Input Voltage Range	187-265 VAC
PowerControl and PowerAssist	Yes
Battery Voltage	48 V
Transfer Switch	50 A
Protection	Overload, Short Circuit, Over Temperature
Communication	VE.Bus, VE.Direct