25H/SP/DDA/2W (1 way “2 wire” DDA audio intercom kit)
On the right of the ‘settings’ tab there are 7 selectable options each with a drop down menu where the
following can be set:
• Speech Playback - the default setting in this eld is set to ‘combined’. By clicking on the drop down
menu button (q) on the right of the eld this setting can be changed. The three options available are:
none, individual and combined (if ‘none’ is selected then there will be no speech playback when a call is
made to the at. If ‘individual’ is selected then the speech annunciation will playback the individual numbers
that make up the at number e.g. if calling at 25 the speech will playback “calling two ve”. If ‘combined’ is
selected then the speech annunciation will playback the combined at number e.g. if calling at number 15
the speech will playback “calling fteen”).
1. Aux.1 Message - when set into mode 1 the text entered into the ‘Aux.1 display text’ elds
will be shown on the UIM-138 display.
2. Call ID.1 - when set into mode 2 the UIM-138 will trigger the 138N speaker amp to call
phone ID.1 (particularly useful if a 2210A or 2210V concierge unit is being used).
3. Scroll < (back) - when set into mode 3 then the UIM-138 display will scroll up through the
list of programmed ats that have been setup in the ‘name’ eld under the ‘apartments’
tab (refer to page 19 ).
4. Call ID.25 - when set into mode 4 the UIM-138 will trigger the 138N speaker amp to call
phone ID.25.
• Aux.2 Mode - the following modes can be set and will be active when auxiliary input I2 is triggered:
1. Aux.2 Message - when set into mode 1 the text entered into the ‘Aux.2 display text’ elds
will be shown on the UIM-138 display.
2. Activate AO - when set into mode 2 the UIM-138 display will trigger the AO output.
3. Call - when set into mode 3 then the UIM-138 display will allow a call to be made to a at
that has been selected using the scroll up/down buttons.
4. Call ID.26 - when set into mode 4 the UIM-138 will trigger the 138N speaker amp to call
phone ID.26.
• Aux.3 Mode - the following modes can be set and will be active when auxiliary input I3 is triggered:
1. Aux.3 Message - when set into mode 1 the text entered into the ‘Aux.3 display text’ elds
will be shown on the UIM-138 display.
2. MODE 2 - currently unavailable, left for future expansion.
3. Scroll > (forward) - when set into mode 3 then the UIM-138 display will scroll down
through the list of programmed ats that have been setup in the ‘name’ eld under the
‘apartments’ tab (refer to page 19).
4. Call ID.27 - when set into mode 4 the UIM-138 will trigger the 138N speaker amp to call
phone ID.27.
• Aux.1 Mode - the following modes can be set and will be active when auxiliary input I1 is triggered:
Clicking on the drop down menu button (q) on the right of the eld the required auxiliary mode can be set
(a table of auxiliary input modes can be found on page 11):
To Next Page
Loading...
