25H/SP/DDA/2W (1 way “2 wire” DDA audio intercom kit)
The ‘apartments’ tab is set out with 6 columns; Mem, Apt No., Phone ID, Block ID, Access Code and Name (as
shown below) and several eld rows. The ‘Mem’ column (memory location) is already completed.
Under the ‘apartments’ tab the following elds can be edited:
• Apt No. - the apartment number or at number can be entered into this eld (The apartment number
entered into this eld will be shown on the top line of the UIM-138 display when a call is made to that
apartment).
• Phone ID - the address of the intercom phone in the apartment can be entered into this eld.
• Block ID - if an Art.2206N bus exchange device is used then the block ID can be entered into this eld.
(Information completed in this eld will only be applicable on multiple entrance systems where an Art.2206N
bus exchange device has been used).
• Access Code - this eld is not used.
• Name - the name of the user or the apartment or oce name can be entered into this eld and will be
available to select if the ‘scroll and call’ modes (described on page 17) have been setup on auxliliary inputs
I1, I2 and I3 on the UIM-138 display. (The information entered into this eld will be shown on the second line
of the UIM-138 display when a call is made to that apartment).
Apartments
At the top of the main programmer screen there are 9 menu options available: File, System, Download,
Upload, Sort, Language, Communication, Baud and About. As previously mentioned on page 16 not all of
these menu options are applicable when using the UIM-138 display module.
From the top menu on the main programmer screen when ‘File’ is selected the following drop down menu
will appear (as shown on page 20) and the following options are available:
File
Programmer Screen Top Menu
To Next Page
Loading...
