25H/SP/DDA/2W (1 way “2 wire” DDA audio intercom kit)
• Exit - select this option when all programming is nished to exit out of the programmer software. (please
note that when exiting out of the programmer software a prompt window will appear asking if you want to
save the current le before exiting, click on the required button. If saving the le again it will be saved in the
same le location as described above under the ‘save as’ function).
From the top menu on the main programmer
screen when ‘System’ is selected the following drop
down menu will appear (as shown). There are four
options shown on the drop down list, however the
‘UIM-138’ option will already be ticked. The other
three options will not be applicable this is because
when the programmer software rst loads up it will
automatically detect that a UIM-138 display module
is connected.
System
Download
From the top menu on the main programmer screen
when ‘Download’ is selected the following drop
down menu will appear (as shown). Clicking on
‘Download All’ will download all the programming
from the existing UIM-138 display module that the
programmer software is connected to.
To Next Page
Loading...
