25H/SP/DDA/2W (1 way “2 wire” DDA audio intercom kit)
If the ‘Check Connection’ option is then selected from the ‘Communication’ drop down list the
programmer software will then search for the COM port that the display module is connected to and
re-establish a link. This can be seen to the right to the progress bar as shown below.
Once the COM port has been found by the programmer software the status bar will update. This can
be seen to the left of the progress bar. Conrmation of which COM port the UIM-138 display module
is connected to can be seen to the right of the progress bar as shown below.
• Detected - this status is shown when the programmer software has found a device (UIM-138 display
module) attached to the PC, as shown below.
• Opened File - this status is shown when the programmer software has successfully opened a saved
le using the ‘Open’ or ‘Open Recent’ option from the ‘File’ drop down list. The status will update to the
right of the progress bar as shown below.
• Saved File - this status is shown when the programmer software has successfully saved an open le
using the ‘Save’ or ‘Save As’ option from the ‘File’ drop down list. The status will update to the right of
the progress bar as shown below.
• Downloading Settings - this status is shown when the programmer software downloads all the existing
settings saved on the UIM-138 display module. This is done by selecting ‘Download All’ from the
‘Download’ drop down list from the top menu. The status and download progress can be seen to the
right of the progress bar as shown below.
• Uploading Settings - this status is shown when the programmer software uploads all the current
settings from an open le into the UIM-138 display module. This is done by selecting ‘Upload All’ from
the ‘Upload’ drop down list from the top menu. The status and upload progress can be seen to the right
of the progress bar as shown below.
To Next Page
Loading...
