Videx 6200 Series - Intercommunicating Call Feature; Initiating Intercom Calls; Call Status Indicators; Conversation Status Display

66251115 - V4.1 - 31/07/19
- 12 -
6200 Series
Art.6296 - Installation instructions
INTERCOMMUNICATING CALL
The videophone, if properly congured, allows intercommunication with other videophones
• By pressing the
button, if the “Intercoms Address Book” is not empty (Fig. 47), will start a intercommunicating call with the
favourite intercom*.
• If you have not picked up the handset the videophone gives a warning to do it (Fig. 48).
• The calling videophone shows the outgoing call symbol followed by the name of the called videophone (Fig. 49) while the called
videophone shows the incoming call symbol followed by the name of the calling videophone (Fig. 50).
• When the called videophone answers it starts the conversation between the videophones, the caller (Fig. 51) and the called
(Fig. 52) shows the speech symbol followed by the name of the connected videophone.
• The conversation stops when one of the two hangs up the handset
* Note that favourite videophone is set during the system conguration using the “Videx IP Wizard” software.
15:30
MAIN MENU
Intercoms Address Book
Is Empty
Fig. 47 Empty “Intercoms Address Book” Fig. 48 Pick up the handset warning
First Floor
Fig. 49 Outgoing call on calling videophone
Ground Floor
Fig. 50 Incoming call from on called videophone
First Floor
Fig. 51 Conversation in progress on calling videophone
Ground Floor
Fig. 52 Conversation in progress on called videophone
Art.6296
IP Videophone for VIDEX IP System