Videx 6200 Series - Privacy Service Management; Enabling Privacy Mode; Disabling Privacy Mode; Using the Service Button

66251115 - V4.1 - 31/07/19
- 9 -
6200 Series
Art.6296 - Installation instructions
TO ENABLE PRIVACY SERVICE
When the service is enabled the videophone doesn’t receive external or internal calls.
• Press the
button to enable the privacy service (Fig. 33). The relevant LED illuminates.
• To disable the service proceed again as above (Fig. 34)
15:30
MAIN MENU
Privacy mode enabled
Fig. 33 Privacy service enabled
15:30
MAIN MENU
Privacy mode disabled
Fig. 34 Privacy service disabled
USING THE SERVICE BUTTON
The
button operates only if previously set using the “Videx IP Wizard”. If it is pressed during the conversation or when the monitor
is in stand-by, it will operate according to the setup made.
Main Entrance
M.E. Pedestrian Gate
Fig. 35 Activating a relay during the conversation
15:30
MAIN MENU
B.E. Car Gate
Fig. 36 Activating a relay during the stand-by
Art.6296 IP Videophone for VIDEX IP System