How to edit track diagrams:
• Select the desired track diagram.
• Activate the menu “track diagram
editor” by pressing the system-touch
eld (left down below).
• In order to open the editor push slightly
on the respective symbol next to the
label “Track diagram”.
You are now in the track diagram editor
and you can see the raster eld of the
chosen track diagram just in the middle.
On the left you see an arrangement of
touch elds representing different catego-
ries of symbol eld types (Track symbols,
turnout symbols, signal symbols etc.).
You select the respective category.
The elds belonging to this category are
displayed at the top. On the left is a selec-
tion list where the just active eld type will
be pointed out by an enlargement and indi-
cates you the item-no of the track-symbol.
On the right you have touch elds in order
to administrate the track diagram:
Delete track diagram (can-
cels the whole diagram)
Load track diagram (loads
down the last saved con-
guration of the diagram)
Save track diagram (saves
the actual conguration of
the track diagram)
Editing track diagrams is very easy:
• Select the desired eld type out of the
different categories of symbol eld
types. The respective symbol is
displayed on the selection list and at
the same time on the actual position of
the cursor on the track diagram-area.
• Drag it to the nal position with your
nger or an electronic pen.
• Turn the symbol as long as it points to
the right direction with the speed-knob.
• Press now the navigator or speed knob
until you hear a click, in order to x the
symbol in the track diagram.
This way you can draw eld by eld the
whole track diagram.
• By pressing the “Save”-symbol you
save the track diagram.
• After that you leave the track diagram
editor by touching the key “Exit”.
To Next Page
Loading...
