Information:
You need a PC equipped with the
windows system and USB 2.0
connection jacks for the update.
Attention:
Switch of all energy saving options!
Your computer de nitely should not
switch over to the standby mode or to
the state of rest. This can especially
occur to laptops. Adjust the energy
saving options by windows before
executing the update.
How to update the Commander:
The software update can easily be
installed on the Commander by yourself.
• Connect the switched on Commander to
the PC by an USB-cable.
• Install the driver for the USB-interface at
the rst interconnection of Commander
and PC.
You will nd the driver on the DVD.
• Press the system-menu touch eld (left
down below) in order to open the
“system-parameter”-menu.
• You activate the software mode at a
slight touch on the respective symbol
next to the label “software update”.
The Commander is now in the software
update mode.
• Please respect the information
of the Commander.
• To start up the update software double-
click on your PC.
• Follow the instruction of the update
software on your PC.
Attention:
As the update of the Commander can
take up to 20 minutes, please don’t get
impatient.
Never cut off the power supply of the
Commander during the update procedu-
re! In consequence of an incomplete
update the Commander may not boot
up any more. Sending in the
Commander to the Viessmann
after-sales-service is unavoidable then
and at the owner‘s expense startet.
To Next Page
Loading...
