Solar technology Vitosol 200-T
VITOSOL 200-T
In the 200-T there are a number of additional
installation benefits, as the tubes can be
fitted onto flat roofs without the need for an A
frame, and they are also suitable for horizontal
installation onto walls.
Heat pipe collectors are best applied
when the system is expected to be used
intermittently or when the heating capacity
will often be greater than the heating
requirement, as this presents a high risk
of stagnation.
Highly efficient vacuum tube collector
based on the heat pipe principle for high
operational reliability against overheating
The Sol-titanium coated absorber surfaces,
which are integrated into the vacuum tube,
are not susceptible to contamination
Tubes can be rotated for optimum
alignment with the sun, thereby
maximising the energy yield
Highly effective thermal insulation of
the header casing for minimal thermal
losses, enabling conversion of even low
levels of solar radiation
Patented and highly effective Duotec
twin-pipe heat exchanger
Easy installation through the Viessmann
assembly and connection systems
The new Vitosol 200-T vacuum tube collector is based on the heat pipe principle,
in common with the 300-T.
1
2
3
4
5
6
Vitosol Heat Pipe
1
Highly effective thermal insulation
2
"Dry" connection, no direct contact
between process and heat
transfer medium
3
High-grade, low ferrous glass
4
Duotec twin-pipe heat exchanger
5
Heat pipe
6
Sol-titanium coated absorber
Vacuum tube collector Vitosol 200-T
Heat pipe system
Type SP2 SP2
Version
m
2
2 3
Gross area
m
2
2.88 4.32
Absorber area
m
2
2.00 3.02
Aperture area
m
2
2.15 3.23
Dimensions
(overall)
Depth
Width
Height
mm
mm
mm
143
1 420
2 040
143
2 129
2 040
Weight
(incl. thermal insulation)
kg 58 87
To Next Page