Using the Display Features
13
Operation
Turning the Display On and Off
Press
on the remote control.
You can also use the
key on the front side of the panel.
* If there is no input signal within 10 minutes, the display will be
turned off automatically.
Adjusting the Volume
Press VOL +/- to adjust volume.
To turn off the volume, press MUTE.
To restore volume, press MUTE again, or press VOL +/- directly.
Viewing the Displayed Information
To display the current information of the display:
Press INFO, and the current state will be displayed on the screen.
(It shows all or some of the information about Input, Resolution,
etc., depending on the input source)
* The illustration shows an example of the INFO screen in an HDMI source.
1080p 60Hz
Aug-18 15:02 Sat
HDMI
To Next Page
Loading...
Need help?
General