ViewSonic PJ506D User Manual

16ViewSonic PJ506D
Powering On/Off the Projector
Powering on the projector:
1. Remove the projector lens cap.
2. Complete the AC power cord and peripheral signal cable(s) connections.
3. Press button to turn on the projector.
4. Turn on your source (computer, notebook, DVD, etc.). The projector automatically
detects your source.
When searching message appears on the screen, ensure that the appropriate
signal cable(s) are securely connected.
The signal message will appear on the screen when the source is detected.
 If you are connecting multiple sources to the projector simultaneously, press
Source button.
Warning:
Remove the lens cap rst before powering on.
Never look into the lens when the lamp is on. This can damage your eyes. It
is especially important that children are not allowed to look into the lens.
Powering Off the Projector:
1. Press button to turn off the projector lamp. You will see a message “Power
Off? Press Power again” appear on the screen.
2. Press button again to conrm.
3. The cooling fans continue to operate for cooling cycle and the Lamp LED goes
out.
When the Power LED begins flashing, the projector has entered standby
mode.
If you wish to turn the projector back on, you must wait until the projector has
completed the cooling cycle and has entered standby mode.
Once in standby mode, simply press button to restart the projector.
4. Disconnect the power cord from the electrical outlet and the projector.
5. Do not turn on the projector immediately following a power off procedure.
Please wait until the fan motor and the Lamp LED turn off before removing
the AC power cord from the projector.

ViewSonic PJ506D Specifications

General

Native resolution	SVGA (800x600) pixels
Service life of lamp	3000 h
Bulb power	200 W
Power consumption (typical)	250 W
Input type	NTSC M, NTSC 4.43, PAL, SECAM, HDTV

Weight and Dimensions

Weight	5.7 g
Dimensions (WxDxH)	256 x 223 x 102 mm