ViewSonic PJ506D User Manual

ViewSonic PJ506D17
Adjusting the Projected Image
Adjusting the Projector Height
The projector is equipped with an elevator foot to adjust the image height.
To raise the image:
1. Press the elevator button.
2. Raise the image to the desired height angle, then release the button to lock the
elevator foot into position.
To lower the image:
1. Press the elevator button.
2. Lower the image, then release the button to lock the elevator foot into position.
To avoid damaging the projector, make sure that the elevator foot is fully
retracted before placing the projector in its carrying case.
Elevator foot
Elevator button

ViewSonic PJ506D Specifications

General

Native resolution	SVGA (800x600) pixels
Service life of lamp	3000 h
Bulb power	200 W
Power consumption (typical)	250 W
Input type	NTSC M, NTSC 4.43, PAL, SECAM, HDTV

Weight and Dimensions

Weight	5.7 g
Dimensions (WxDxH)	256 x 223 x 102 mm