34ViewSonic PJ588D/PJ568D/PJ508D
Cleaning the Projector
Cleaning the projector to remove dust and grime will help ensure trouble-free operation.
Warning:
Be sure to turn off and unplug the projector at least an hour before cleaning. Failure to do so could result in a severe
burn.
Use only a dampened cloth when cleaning. Do not let water to enter the ventilation openings on the projector.
If a little water gets into the projector interior while cleaning, leave the projector unplugged in a well-ventilated room
for several hours before using.
If a lot of water gets into the projector interior when cleaning, have the projector serviced.
Cleaning the Lens
You can purchase optic lens cleaner from most camera stores. Refer to the following to clean the
projector lens.
1.Apply a little optic lens cleaner to a clean soft cloth. (Do not apply the cleaner directly to the lens.)
2.Lightly wipe the lens in a circular motion.
Caution:
Do not use abrasive cleaners or solvents.
To prevent discoloration or fading, avoid getting cleaner on the projector case.
1.
2.
3.
4.
1.
2.
http://www.pureglare.com.au
To Next Page
Loading...
Need help?
General
