ViewSonic PJ588D User Manual

37 ViewSonic PJ588D/PJ568D/PJ508D
LED Error Messages
ERROR CODE MESSAGE POWER LED/FLASHES READY LED/FLASHES
System standby —
Solid
Cooling
down
Flashing
—
Environment usage task created error
2 2
Thermal
break status error
3 0
Sensor over temperature
3 1
Sensor status fail
4 1
Lamp
lit error
5 1
Ballast
SCI error
5 2
Ballast
UART error
5 3
Fan1
error (Lamp)
6 1
Fan2
error (Ballast)
6 2
Fan3
error (Blower)
6 3
Fan4
error (Power)
6 4
Lamp
door open
7 0
DMD error
8 0
Color wheel error
9 0
Image Problems
Problem: No image appears on the screen
1.Verif
y the settings on your notebook or desktop PC.
2.Turn o
ff all equipment and power up again in the correct order.
Problem: The image is blurred
1.A
djust t
he Focus on the projector.
2.Press t
he Auto button on the remote control or projector.
3.Ensure t
he projector-to-screen distance is within the 8-meter (26-feet) specified range.
4.Check t
hat the projector lens is clean.
5.Make s
ure the output resolution from the PC is 800 x 600 (SVGA model) or 1024 x 768
(XGA model), the native resolution of the projector.
Problem: The image is wider at the top or bottom (trapezoid effect)
1.Positio
n the projector so it is as perpendicular to the screen as possible.
2.Use t
he Keystone button on the remote control or projector to correct the problem.
Problem: The image is reversed or upside down
Ch
eck the Projection se
tting on the Utility menu of the OSD.
Problem: The image is streaked
1.S
et t
he Frequency and Tracking settings on the Utility menu of the OSD to the default
settings.
http://www.pureglare.com.au

ViewSonic PJ588D Specifications

General

Brand	ViewSonic
Model	PJ588D
Category	Projector
Language	English