ViewSonic PJ755D 11
Powering On/Off the Projector
Powering On the Projector
1 . Remove the lens cap.
2 . Ensure that the power cord and signal cable are securely connected. The Power LED will turn red.
3 . Turn on the lamp by pressing “Power/Standby“ button on the control panel.
The start up screen will display for 30 seconds and the Power LED will flash green.
When the startup screen disappears, the Power LED will turn green.
4 . Turn on your source (computer, notebook, video player, etc.). The projector will detect your source
automatically.
* If you connect multiple sources at the same time, use the
“Source” button on the control panel to switch.
* Turn on the
pro-
jector first and
then
the signal
sources.
To Next Page
Loading...
Need help?
General
