Name: ViewSonic PJD5155L
Brand: ViewSonic
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Resetting the filter timer

5. Open the OSD menu and go to the SYSTEM SETTING: ADVANCED > Filter

Settings menu.

6. Press Enter and the Filter Settings page is displayed.

7. Highlight Reset Filter Hours and press Enter. A warning message is displayed

asking if you want to reset the filter timer.

8. Highlight Reset and press Enter. The lamp timer will be reset to '0'.

Caution

• Remember to use Filter Mode to Off in the SYSTEM SETTING: ADVANCED > Filter

Settings menu when using the projector with the dust filter removed. Setting Filter Mode

to Off does not reset the filter timer. The timer will continue counting the next time you

fit the filter back on and set Filter Mode to On.

Installing the cable management cover (optional

accessory)

1. Make sure that all the cables are properly connected to the projector.

2. Attach the cable management cover to the back of the projector.

3. Tighten the screws that secure the cable management cover.

Other manuals for ViewSonic PJD5155L

Questions and Answers:

Need help?

Do you have a question about the ViewSonic PJD5155L and is the answer not in the manual?

General