10
Installation
Power On/Off
1. Connect the power cord to the DC input
jack of the projector.
2. Inset the plug at the end of the power cord
into a power outlet. The status LED lights
red in standby mode.
3. Press the Power button ( ) to turn the
projector on or off. The status LED turns
green when the projector is turned on.
Adjust Projected Image Height
The projector is equipped with an elevator foot for adjusting the projected image
height.
To adjust the height:
Turn the elevator foot to adjust the projected image position to the desired height.
If Auto Keystone is enabled and there are no changes within 2-3 seconds, the projector will automatically
adjust the image display via the Auto Keystone function.
To Next Page
Loading...
