ViewSonic ViewPad 10pi User Manual

8
3. Tap on “Calibration” to start the process.
4. When calibration is completed, message “Calibration OK” will be shown.
Hardware calibration:
You can also calibrate the touch panel by pressing and hold the Back button for 10
seconds until the battery indicator ashes in red.
Connect to a wireless networks
1. Make sure you are located within the wireless network service area. Press the
Wi-Fi button to turn on Wi-Fi, and the Wi-Fi indicator light up in blue. (
If insert a
SIM card, and turn on 3G, you also can conncect to a 3G networks)
2. Click the network icon
in the notication area, a list of available wireless
networks will be displayed.
(
Wi-Fi hotspots and 3G networks will show up
together in the same list. Windows 7 also virtualises
the Wi-Fi card so you can use it twice, for example to
connect WPS device to a non-WPS access point.)
(To connect to some networks that require security
authentication, you may have to undergo another
authorization process and enter username and
password. For details, please consult your network
administrator.)
(For data security, it is strongly recommended
to connect to security-enabled wireless networks
whenever possible.)
(When travelling by air, please be sure to turn o
wireless networking to avoid any possible risks to ight
safety.)
3. Choose a network and then click Connect. If security authentication is not
required by the network you are using, there will be a successful message
showing that you have connected to the network.
The congurations may vary depending on the model number. Check the actual
model for specics.

ViewSonic ViewPad 10pi Specifications

General

Brand	ViewSonic
Model	ViewPad 10pi
Category	Tablet
Language	English