TSGR-21 GAS Release Panel User Manual
Vighnaharta Technologies Pvt. Ltd. Page 29 of 43
In this menu cylinder type specifies that main cylinder or standby cylinder. In Case of Main cylinder is goes for
refilling you can switch over the system on standby cylinder and run the system. By Default it is Main. To change
the state press Enter menu and the use left or right key. Press ENTER key to save the changes.
3) RAC Type:
After entering in the RAC Type menu, LCD displays current setting of RAC Type
In this menu RAC type specifies that RAC Sense is selected as with PR swt or without PR swt. By Default it is
with PR Swt. To change the state press Enter menu and the use left or right key. Press ENTER key to save the
changes.
4) Prog Rly1 Config:
After entering in the Prog Rly1 Config menu, LCD displays current setting of Prog Rly1
In this menu you can configure Prog Rly1 as Fire, Fault, or Gas Release. By Default it is Fault. When there is
fault this relay will activate .To change the state press Enter menu and the use left or right key. Press ENTER
key to save the changes.
4) Prog Rly2 Config:
After entering in the Prog Rly2 Config menu, LCD displays current setting of Prog Rly1
In this menu you can configure Prog Rly1 as Fire, Fault, or Gas Release. By Default it is Gas
Release. When there is GAS Release this relay will activate. To change the state press Enter menu and
the use left or right key. Press ENTER key to save the changes.
3.2.4 Event View:
From selecting this menu You can Enter Below Sub Menus
1) Fire Alarm Event:
After entering in the Fire Alarm Event menu, It will show last fire event. Use Left and right key
to scroll event. LCD Display Shows as below.
2) Fault Alarm Event:
After entering in the Fault Alarm Evnt menu, It will show last fault event. Use Left and right key
to scroll event. LCD Display Shows as below.
To Next Page
Loading...