ACPI Function
Select "Enabled" to activate the function of BIOS Support for Advanced
Configuration and Power Interface features. The settings are "Enabled" or
"Disabled".
ACPI Suspend Type
If enabled, the option allows the user to determine the ACPI Suspend type. The
options are S1 (POS), S3 (STR), and S1&S3.
APIC Mode
This setting allows you to Enable or Disable APIC. APIC is used to assign interrupt
signals to a specific processor on multi-processor system and provides IRQs beyond
the conventional 16 under Windows 2000 or XP. It has no effect on single processor
systems.
MPS Version Control for OS
This setting allows you to state the MPS version for your operating system. Options
are "1.1" and "1.4".
PWRON After PWR-Fail
This setting allows the user to specify how the system will respond when power is
reapplied after the system has gone down due to a power failure. The options are
"Off", "On" and "Former-Sts".
Advanced Chipset Control
Graphics Apertures
This option allows the BIOS to set the size of system memory reserved for AGP
Graphic access. The options are 4, 8, 16, 32, 64, 128, and 256.
CSA LAN(Giga-LA)
This setting allows you to enable or disable the CSA (GLAN) Controller. The options
are "Enabled", and "Disabled."
On-Chip VGA
This setting allows you to enable or disable On-Chip VGA Controller. The options are
"Enabled", and "Disabled."
On-Chip Frame Buffer Size
This setting allows you to set On-Chip Frame Buffer Size. The options are "1 MB", "4
MB", "8 MB", "16 MB" and "32 MB."
Onboard LAN
This setting allows you to enable or disable the Onboard LAN Controller. The options
are "Enabled", and "Disabled."
To Next Page
Loading...
