Use IR Pins
This item sets the usage of the IR pins. The options are "RxD2, TxD2" and "IR-
Rx2Tx2".
Parallel Port Mode
This setting sets the mode for the onboard Parallel port. The options are "SPP,"
"EPP", "ECP" "ECP+EPP" and "Normal".
EPP Mode Select
This setting allows the user to select the EPP port type. The options are "EPP 1.9"
and "EPP 1.7".
Onboard Parallel Port
This setting allows the user to set the address and the corresponding IRQ for the
onboard parallel port. The options are "Disabled", "378/IRQ7", "278/IRQ5" and
"3BC/IRQ7".
Parallel Port Mode
This setting sets the mode for the onboard Parallel port. The options are "SPP,"
"EPP", "ECP" "ECP+EPP" and "Normal".
EPP Mode Select
This setting allows the user to select the EPP port type. The options are "EPP 1.9"
and "EPP 1.7".
ECP Mode Use DMA
This setting allows the user to select the DMA channel for the ECP mode (port) to
use. The options are "1" and "3".
Game Port Address
This setting allows the user to set the address for the Game Port. The options are
"Disabled", "201" and "209".
Midi Port Address
This setting allows the user to set the address for the Midi Port. The options are
"Disabled", "330", "300" and "290".
Midi Port IRQ
This setting allows the user to set the IRQ for the Midi Port. The options are "5",
and"10".
Watch Dog Timer Select
This setting allows you to set the Watch Dog Timer. You must also change the
setting of the Watch Dog jumper in order for this function to work well (-see jumper
settings in Chapter 2). Options are "10 Sec", "20 Sec", "30 Sec", "40 Sec", "1 Min",
"2 Min", "4 Min" and "Disabled".
Power On Function
To Next Page
Loading...
