27
This checklist is designed to enable you to
rectify and problems you experience with your
whirl tub quickly and easily. Work on the electri-
cal equipment must only be completed by an
authorized electrician. The whirl tub must be
isolated from the power supply before and such
work.
Hoesch Design GmbH
If you are unable to recitfy the fault yourself,
please do not hesitate to call our after sales
staff on
+49 (0) 2422/54-0 or fax them on
+49 (0) 2422/54 364.
Fault Cause Remedy
Blower does not work
Pump does not work
No mains voltage
230 V, 50 Hz
Switch on the back-up fuse and / or residual
current-operated circuit breaker (RCCB)
Fusible insert burnt out Have the fuse replaced by an electrician
Dry running protec-
tion system does not
respond
Add water until the red LED
Motor cut-out has trip-
ped due to overheating
Leave the motor to cool for a few minutes
Elektronic controller
Reset the controller, in other words switch
off the power supply for appox. one minute
The massage jet
is soft
Drain valve
To cleanse the drain valve please see
page 34 Cleaning of nozzles
Massage jets
LED spotlight
does not work
Too little water
in the tub
Add water until the red LED
9. Checklist
Subject to technical alterations! Warranty is only granted, if all mentioned instructions were followed.
To Next Page
Loading...
