31
ton 5 for minimum 5 sec. switches on
the wave effect from air jets. Pressing
button 5 while the wave effect is ac-
tive, the wave effect switches off and
speed stabilizes at the current level.
6 button water pump on/off. Short
pressing of button 6 turns on the
pump with the nominal power of
100%.
Pressing the button shortly during
operation, turns off the pump. Press-
ing 6 and holding it for minimum
5 seconds (while pump is on) runs
pulsating massage (water pump will
work in repeated cycles: 3 seconds
maximum speeds, 2 seconds – mini-
mum speeds).
7 red LED indicates power supply and opera-
tion readiness of the unit,
continuous lighting – controller in on, re-
quired water level is reached
no lighting – no power supply of the con-
troller,
“slow” blinking light (1 second) – “STAND-
BY” mode – power supplied to the control-
ler, no operation,
(time measurement to drying cycle)
8 red LED indicates blower operation.
continuous light – air pump on,
(time measurement to drying cycle),
no lighting - air pump off
9 red LED indicates blower speed change,
continuous light – wave effect active from
air jets (continuous change of speed).
no lighting – wave effect not active
10 red LED indicates light operation.
11 red LED indicates blower speed change,
continuous light – wave effect active from
water jets (continuous change of speed).
no lighting – wave effect not active
12 red LED indicates water pump operation.
continuous lighting – water pump on
no lighting – water pump off
13.1 Automatic system shut-down
The operational time of the system is limited
to 20 minutes. After 20 minutes, regardless of
the buttons switched on, the system switches
off automatically. By pressing button 2 and/or 6
you can switch the system on again.
Subject to technical alterations! Warranty is only granted, if all mentioned instructions were followed.
To Next Page
Loading...
