32
Regular disinfection ensures optimal hygiene. It
is recommended to start the disinfection once a
month or every 2-3 bathing.
Notice: In case the bathtub with whirlpool
system was not used for a long time, it is
necessary to start disinfection before the
system is used again.
The proper water level is necessary to start the
disinfection - eventually the water level has to
be up to the level to start the lighting.
■
After you leave the whirlpool, you must
add disinfectant (follow the manufacturer´s
instructions!) to the whirlpool. We recom-
mend that you use disinfectant item no.
6923 or item no. 133607.
Suggested amounts: 100 ml of the disinfecting
agent for 100 L of the bathtub capacity.
Producers tips should be observed.
■
Manual disinfection should be start by the
pushing the button of air or water system
(depends on the system which bathtub
is equipped in).
During the disinfection process (which takes
a total of approx. 30 minutes) the red LED
will be lit.
Manual disinfection process
■
If you add the disinfection agent, the water
system (side jets/pumps) / air system (bot-
tom jets/blower) or mixed system has to
be started to spread the added disinfec-
tion agent and after 1 minute it should be
switched off again manually.
■
After 30 minutes of disinfection process,
the system should be start again for 2 min-
utes (manual start/stop)
■
After disinfection the bathtub should be
emptied.
You should always disinfect the system when
promted in order to meet the necessary hygien-
ic standards.
No liability can be accepted for damages or
consequential damages caused by other agents
not suitable for this purpose.
Subject to technical alterations! Warranty is only granted, if all mentioned instructions were followed.
14. Desinfection
To Next Page
Loading...
