VIKING
standard features
and operator specications
UL325 and UL991 Listed by Underwriter Laboratories (UL) • Accessible manual
release • Fail-Safe option sets the gate to automatically transfer to a fail-safe mode
in the event of a power failure, allowing the gate to be pushed open without the
use of special knowledge of the equipment • Fail-Secure option sets the gate to
mechanically lock in the event of a power failure, allowing no manual movement
without the use of the manual release • Elegant design, appealing to any architectural
project • Plated and powder coated steel chassis • Opening up to 120° • Operation
speed of 13 to 16 seconds per 90° • 100% duty cycle under very wide temperature
range • Very low power consumption • 300 cycles of operation on backup battery
(600 lb. gate and 12' length) • Intelligent speed control with smooth start and stop,
self-adjust system • Modulated speed regulator prevents exceeding operating speed
that may reduce the service life of the gate operator and/or installation • Intelligent
obstruction detection with adjustable sensitivity • Overlap delay that holds one gate
momentarily by an adjustable time while the other gate is operating (Master/Slave
installation with overlap gates) • Built-in protection against lightning strikes or similar
electrical surges • Inherent overload protection in the regulated power supply
for external accessories with multiple devices of protection
• Modular connectors for easy installation • Solar
panel and low voltage wiring compatibility
• LED indicators for verication of
operation
Viking Access Systems
Phone 800.908.0884 Fax 949.753.1640
631 Wald Irvine, CA 92618
www.vikingaccess.com
To Previous Page
Loading...
