EasyManua.ls Logo

Viking MT 830 - Raising the Hood & Seat; Checking; Adding Fuel; Check Tire Pressures

Viking MT 830
144 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN - 24
Regular Maintenance
RAISING THE HOOD & SEAT
To raise the hood, grasp the hood recess (Figure 9) on
top, then pivot the hood up and forward.
To raise the seat for battery access, tilt the seat forward.
CHECKING/ ADDING FUEL
To add fuel:
1. Remove the cap from the fuel tank (A, Figure 10).
2. Fill the tank. Do not overfill. Leave room in the tank
for fuel expansion. Refer to your engine manual for
specific fuel recommendations.
3. Install and hand tighten the fuel cap.
CHECK TIRE PRESSURES
Service Interval: Every 25 Hours
Tire Pressure should be checked periodically, and main-
tained at the levels shown in the chart. Note that these
pressures may differ slightly from the “Max Inflation”
stamped on the side-wall of the tires.The pressures
shown provide proper traction, improve cut quality, and
extend tire life.
NOTICE
Do not run the tractor with the hood raised.
Engine heat will damage the headlight bezel
and hood.
Do not use gasoline containing METHANOL,
gasohol containing more than 10% ETHANOL,
gasoline additives, or white gas because
engine/fuel system damage could result.
Gasoline is highly flammable and must be handled with
care. Never fill the tank when the engine is still hot
from recent operation. Do not allow open flame,
smoking or matches in the area. Avoid over-filling and
wipe up any spills.
Do not remove fuel filter when engine is hot, as spilled
gasoline may ignite. DO NOT spread hose clamps
further than necessary. Ensure clamps grip hoses
firmly over filter after installation.
WARNING
Figure 9. Gas Tank Located Under Hood
Figure 10. Engine Compartment
A. Gas Tank C. Fuel Filter
B. Air Filter D. Spark Plug
Figure 11. Checking Tire Pressure
Tire Pressure
Front 0,83-1,04 bar
Rear 0,69-0,83 bar
A
B
C
D
Hood Not Shown
For Clarity
Hood Recess

Table of Contents

Related product manuals